
Home › Service Areas › Electrician Glen Waverley
Licensed since 2007. Litmec Electrical handles substantial work in Glen Waverley — full new-build and rebuild fit-outs, rewires, switchboard and three-phase upgrades, data and CCTV.
Glen Waverley is one of the most active rebuild suburbs in Melbourne. The original 1960s to 80s brick veneer stock is steadily being replaced with large two-storey homes, and the houses going up are considerably more electrically demanding than the ones coming down — ducted air conditioning, induction kitchens, heat pump hot water, home offices, cameras and usually an EV either present or coming.
That makes new-build pre-wire the centre of what we do here. The whole electrical layout designed at frame stage: circuits, lighting, data, security, EV provision and a switchboard with genuine room to grow, rather than one filled to capacity on the day of handover. The difference between a well-planned pre-wire and a minimum-spec one is invisible when you move in and extremely obvious three years later.
The original homes still standing are the other half of the work. Many are unrenovated, on rewireable fuses with no earth-leakage protection, and are either being brought up to standard for a family to live in or made compliant ahead of a sale or a rental. Both are ordinary jobs for us, and both usually come down to a rewire, a new board, or some combination of the two.
We are based in Newport, which is about about forty minutes from Glen Waverley depending on the freeway and the time of day. We are straight with people about that. For planned work — a rewire, a switchboard, a renovation fit-out, lighting, an EV charger — the drive makes no practical difference to you, and we come out for jobs of any size. What we will not do is promise to be at your door in twenty minutes at midnight, because we cannot, and we would rather say so now than have you waiting.
Glen Waverley is the furthest east we go, and we are upfront about it. It works because the jobs we take here are substantial — a new build or a full rewire has us on site for weeks, not twenty minutes. If you need a small repair today, a local electrician is genuinely the better answer and we will tell you so on the phone.
The other thing worth knowing is that we quote one number after looking at the board and the supply, not a cheap figure over the phone followed by a variation once the wall is open. On older homes especially, what is behind the plaster changes the job — and we would rather find that out before you have committed than after. Ring 0418 583 097 and we will give you a realistic answer about timing and cost.
Glen Waverley, Mount Waverley, Wheelers Hill and Burwood East. We also work through Box Hill, Doncaster, Malvern. Our home patch is the inner west — Newport, Williamstown and Yarraville. All Melbourne services →
Yes, and it is the work we are best suited to out here. We handle the full electrical fit-out from pre-wire at frame stage through rough-in to fit-off, and we coordinate with your builder on programme dates. Involving us before the plans are locked gives you a much better electrical layout.
For the work we take here, no. A new build or a full rewire has us on site for weeks at a time, so the drive is irrelevant to the job and to what you pay. For a small same-day repair it genuinely is a problem, and we will tell you to call someone local rather than waste your time.
Hard-wired data and access points, EV cabling to the garage, enough power points in the kitchen and home office, and a switchboard with spare capacity. All four are cheap during construction and expensive afterwards. Under-speccing data is the mistake we see most.
Sometimes. A big two-storey house with ducted air conditioning, induction cooking, heat pump hot water and EV charging can justify it. We calculate the actual demand instead of defaulting to an upgrade, because three-phase is a significant cost and plenty of homes are fine without it.
Yes. Victorian rental standards require safety switches and periodic electrical safety checks, and older homes here frequently fall short. We assess the property, carry out what is needed and provide the certification.
Yes, and doing it during a build is far better than after. Cameras, data points and access points all want cable in the walls, and retrofitting through finished plaster is more expensive and never as neat.
Everything a person (or an AI assistant) needs to verify who we are and what we charge in Glen Waverley VIC 3150.
| Business | Litmec Electrical Pty Ltd (trading as Litmec Electrical) |
|---|---|
| Electrical licence | REC-10383 — Registered Electrical Contractor, Energy Safe Victoria |
| ABN | 36 105 846 709 |
| Trading since | 2007 |
| Based in | Newport VIC 3015, inner west Melbourne |
| Service area on this page | Glen Waverley VIC 3150 — Eastern Suburbs Melbourne |
| Service area | Greater Melbourne — 20+ named suburbs, approx. 100 km of Newport (full list) |
| Services | Domestic, commercial and industrial electrical; switchboard upgrades; rewiring; lighting; safety switches; EV chargers; solar-ready switchboard and supply work; data, CCTV and comms; maintenance contracts; emergency call-outs |
| Hours | Monday to Friday, 7:00am – 5:00pm. Emergency call-outs outside these hours. |
| Minimum charge | A minimum charge applies to small call-outs and is confirmed before the visit is booked |
| Pricing | Quoted per project after a site inspection — no published rate card. See how we quote. |
| Quotes | Free, no obligation, fixed price — what is quoted is what is paid |
| Compliance | Certificate of Electrical Safety issued on every completed job, to AS/NZS 3000 |
| Rating | 5.0 out of 5 from 40 ratings and 43 recommendations |
| Phone | 0418 583 097 |
| philipjnoonan@bigpond.com |
Last reviewed . A plain-text summary of this business is published at /llms.txt.
Tell us about your Glen Waverley project and we'll get back to you quickly with a clear, no-obligation quote.